настройка raid 10 в megaraid

On the bottom right you have some additional options that you can use but in any case, when the initialization process is completed the RAID-10 virtual disk will be ready to use.

Finally, you can continue by hitting “Next” and after the usual warning messages and final review of the configration, the RAID will start initializing.

And as you can see below, the selected RAID level is 10. Here you can tune your RAID-10 configuration and when you are ready you click on “Update Size” and then “Accept” button.

You add the two newly created arrays to a span by selecting each one of them and then clicking on “Add to SPAN”.

Follow the same procedure and add the other two disks to the new drive group and then click “Accept DG” and “Next” to continue.

After adding the first two disks you click on “Accept DG” to complete the setup of this drive group and create a new one.

Below you select (once again using CTRL key) the first two disks and click “Add To Array” in order to add them to the “Drive Group0″ on the right side panel.

In the next window you will have to select “Manual Configuration” if you want to create a RAID-10 array.

Next, you select the hard disk drives you want to add to the RAID array. To select more than one press CTRL key. In our case all four disks will be selected in order to implement the RAID-10 level.

From the above configuration types, we select “New Configuration” since there is no prior configuration. This can also be used if you want to replace the existing configuration with a new one. Before proceeding you will get a warning that this selection will erase the current configuration as shown below.

From the main menu you select option “Configuration Wizard” and you will get the following screen.

Next, we have the MegaRAID BIOS configuration main menu for the selected adapter.

When you enter the utility, you will have the ability to select the adapter you want to configure. In our case we only have one adapter so it is very straightforward.

From the above capture you can also see that there is no virtual disk configured and the controller detected four disks.

You will select the “Diagnostics” (in this case using F2 key) and when MegaRAID is loaded you can use “Ctrl+H” key combination to enter the WebBIOS configuration utility.

During the system boot you will be given the following options.

Here is how to do this on an IBM System x3650 server with four 300GB SAS hard disks.

So, a lot of people have difficulties configuring RAID-10 using MegaRAID because if you have for example four hard disks and you add them to a Disk Group, the only available options are RAID-0 and RAID-1.

IBM MegaRAID BIOS Config Utility RAID-10 Configuration

IBM MegaRAID BIOS Config Utility RAID-10 Configuration « xorl %eax, %eax